Search for Air Lift WirelessONE. Now the manifold will boot into join mode and will click the exhaust solenoid 5 times fast then one per second.
Wireless Air 2nd Generation. Download the Devices free Air Lift WirelessONE app from Google Play for Android. The manifold will remain in pairing mode for three minutes after the fuse is reinserted. Air line not attached to air bags, loose air line, or leak in system. WirelessAir™ is an advanced wireless controller that lets you rule your air spring system, no strings attached. American Owned & Operated. Watch the App Video. Connect directly to battery through fused wire to verify that it isn’t a wiring problem. Remove the cap leaving it attached to the harness. The Replacement Remote for Air Lift WirelessONE Compressor System for Air Helper Springs # AL72704 needs to be synced.
Locate the sync wire in the wire harness. Since 1949. Faulty compressor. Turn ignition on. 2. Own the Air. Remove the yellow wire from the cap leaving the cap attached to the harness. • Remove the yellow wire from the … It will be the yellow wire that is looped with a yellow cap around it. The controller can be put into "join" mode by pressing the Up and Down buttons together, selecting the M1 button when the display flashes "JOIn" and then selecting either the front of rear axle.
Watch the video Where to buy. Designed, engineered, and assembled by Air Lift Company in Lansing, Michigan, using only the finest components from around the world. 4. WirelessOne™ lets you instantly control your air springs without emptying your wallet. 1. Leak check. Attach the exposed terminal to a good frame ground.
You will want to set the manifold to "join" mode by grounding the yellow join wire and then cycling power to the manifold. Rule the Air. Page 14: Navigation/Communicate 2. To sync the remote use the following steps: 1. • Locate the YELLOW join wire with heat shrink on the end in the harness. Call Tech Support at 1-800-248-0892, ext 2 if compressor is faulty or the actions do not work The manifold will stay in join mode for 30 seconds. ; Three user-defined memory buttons; Standard-duty air compressor WirelessOne. • Ground the join wire in the electrical harness. Trace all air lines and observe connections for faults. Single path control: left and right air springs are inflated/deflated equally Wireless handheld unit for convenient operation inside or outside the vehicle; Easy installation - no air lines to the cab! Set the manifold into join mode. 3. The FREE WirelessOne Mobile app duplicates the functionality of the remote and can be used with multiple WirelessOne manifolds. Put the manifold in pairing mode by removing the fuse to the battery and reinstalling it after five seconds.